Stereo-based image processing for spatter detection in PBF-LB/M of Ti-6Al-4V
DOI:
https://doi.org/10.58134/fh-aachen-rte_2024_010Keywords:
Additive Manufacturing, Ti-6Al-4V, PBF-LB/M, Spatter, melt pool, process monitoringAbstract
Spattering is an inevitable by-product of the laser-based powder bed fusion of metals (PBF-LB/M) that can lead to deterioration of the part properties as well as degradation of the unmolten powder. To understand the spattering phenomenon and develop effective countermeasures, a monitoring system is required that can record and process the 3-dimensional movement behavior of the spatter particles. In this work, a stereo-vision camera setup with subsequent image analysis is presented for the PBF-LB/M of the titanium alloy Ti-6Al-4V. The influence of the process parameters laser power and scanning speed on spatter generation is also investigated experimentally. Spatter speeds between 13.01 m/s and 35.77 m/s were determined. The results show a correlation between spatter generation and volume energy density. An increase in spatter amount was observed when the laser power was increased, or the scanning speed was reduced. Further, as the volume energy density increased, the spatter velocity also increased, and the spatter size decreased. In addition to the process parameters, the influence of the gas flow on the spatter trajectory is considered. The gas flow in the process chamber causes a change in the direction of the spatter trajectories as they leave the process zone. Spatters already moving parallel to the gas flow are accelerated. This work highlights the importance of a 3-dimensional monitoring of the spattering to develop a deeper understanding of the underlying mechanisms and shows that by adjusting the process parameters the process can be significantly influenced.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Nicole Emminghaus, Tim Klügel, Jörg Hermsdorf, Stefan Kaierle

This work is licensed under a Creative Commons Attribution 4.0 International License.
